S-Video Cables

more...

Home
Amplifiers
Audio Accessories & Cables
Cable TV
DVD Players & Recorders
Digital Video Recorders, PVR
Gadgets & Other Electronics
Home Audio
Home Theater Projectors
Home Theater in a Box
Radios: CB, Ham & Shortwave
Satellite Radio
Satellite TV
Telephones & Pagers
Televisions
Accessories & Cables
Other
TV Antennas
TV Stands
Video Cables
Adapters, Converters
Analog
Digital, Non-HDTV
HDTV
HDTV Cables
S-Video Cables
Standard Cables
Coaxial
Component
Composite (RCA)
DVI
Other
S-Video
Video Selectors, Switches
Wall Mounts & Brackets
Direct-View Standard TVs
DVD/VCR Combo TVs
HDTV Receivers, Tuners
HDTVs, Direct-View
LCD Flat-Panel TVs
Other
Plasma TVs
Portable TVs
Rear Projection TVs
VCRs
Vintage Electronics

Separate video, abbreviated S-Video and also known as Y/C (or erroneously, S-VHS and "super video") is an analog video signal that carries the video data as two separate signals (brightness and color), unlike composite video which carries the entire set of signals in one signal line. S-Video, as most commonly implemented, carries high-bandwidth 480i or 576i resolution video, i.e. standard definition video. It does not carry audio on the same cable.

Overview

The luminance (Y; greyscale) signal and modulated chrominance (C; colour) (A; audio)information are carried on separate synchronized signal/ground pairs.

In composite video, the luminance signal is low-pass filtered to prevent crosstalk between high-frequency luminance information and the color subcarrier. S-Video separates the two, and detrimental low-pass filtering is unnecessary. This increases bandwidth for the luminance information, and also subdues the color crosstalk problem. The infamous dot crawl is eliminated. This means that S-Video leaves more information from the original video intact, thus having a much-improved image reproduction compared to composite video.

Due to the separation of the video into brightness and colour components, S-Video is sometimes considered a type of component video signal, although it is also the most inferior of them, quality-wise, being far surpassed by the more complex component video schemes (like RGB). What differentiates S-Video from these higher component video schemes is that S-Video carries the colour information as one signal. This means that the colours have to be encoded in some way, and as such NTSC, PAL and SECAM signals are all decidedly different through S-Video. Thus, for full compatibility the used devices not only have to be S-Video compatible but also compatible in terms of colour encoding.

Connector

Today, S-Video signals are generally connected using 4 pin mini-DIN connectors using a 75 ohm termination impedance. Apart from the impedance requirement, these cables are equivalent to regular mini-DIN cables (like Apple's ADB); these cables can be used for S-Video transfer if no other cable is available, but picture quality may not be as good. Due to the wide use of S-Video connections for DVD players, S-Video cables are fairly inexpensive compared to component or digital connector cables, and are routinely available in places where the higher-bandwidth cables are not.

The mini-DIN pins, being weak, sometimes bend. This can result in the loss of color, or other corruption (or loss) in the signal. A bent pin can be forced back into shape, but this carries the risk of further damage, or even the pin breaking off.

Read more at Wikipedia.org