Coaxial

Coaxial cable is an electrical cable consisting of a round conducting wire, surrounded by an insulating spacer, surrounded by a cylindrical conducting sheath, usually surrounded by a final insulating layer. more...

Home
Amplifiers
Audio Accessories & Cables
Cable TV
DVD Players & Recorders
Digital Video Recorders, PVR
Gadgets & Other Electronics
Home Audio
Home Theater Projectors
Home Theater in a Box
Radios: CB, Ham & Shortwave
Satellite Radio
Satellite TV
Telephones & Pagers
Televisions
Accessories & Cables
Other
TV Antennas
TV Stands
Video Cables
Adapters, Converters
Analog
Digital, Non-HDTV
HDTV
HDTV Cables
S-Video Cables
Standard Cables
Coaxial
Component
Composite (RCA)
DVI
Other
S-Video
Video Selectors, Switches
Wall Mounts & Brackets
Direct-View Standard TVs
DVD/VCR Combo TVs
HDTV Receivers, Tuners
HDTVs, Direct-View
LCD Flat-Panel TVs
Other
Plasma TVs
Portable TVs
Rear Projection TVs
VCRs
Vintage Electronics

It is used as a high-frequency transmission line to carry a high-frequency or broadband signal. Sometimes DC power (called bias) is added to the signal to supply the equipment at the other end, such as for the LNBF connecting to a direct broadcast satellite receiver. Because the electromagnetic field carrying the signal exists (ideally) only in the space between the inner and outer conductors, it cannot interfere with or suffer interference from external electromagnetic fields.

Coaxial cables may be rigid or flexible. Rigid types have a solid sheath, while flexible types have a braided sheath, both usually of thin copper wire. The inner insulator, also called the dielectric, has a significant effect on the cable's properties, such as its characteristic impedance and its attenuation. The dielectric may be solid or perforated with air spaces. Connections to the ends of coaxial cables are usually made with RF connectors.

Signal propagation

Open wire transmission lines have the property that the electromagnetic wave propagating down the line extends into the space surrounding the parallel wires. These lines have low loss, but also have undesirable characteristics. They cannot be bent, twisted or otherwise shaped without changing their characteristic impedance. They also cannot be run along or attached to anything conductive, as the extended fields will induce currents in the nearby conductors causing unwanted radiation and detuning of the line.

Coaxial lines solve this problem by confining the electromagnetic wave to the area inside the cable, between the center conductor and the shield. The transmission of energy in the line occurs totally through the dielectric inside the cable between the conductors. Coaxial lines can therefore be bent and twisted (subject to limits) without negative effects, and they can be strapped to conductive supports without inducing unwanted currents in them. The inner conductor can be made of braid and the outer conductor can be made of corrugated tube for greater flexibility, but this comes at the cost of increased ohmic losses and lower phase velocity. The outer conductor can also be made of (in order of increasing leakage) wound foil, woven tape, or braid.

In radio-frequency applications up to a few gigahertz, the wave propagates only in the transverse electric magnetic (TEM) mode, which means that the electric and magnetic fields are both perpendicular to the direction of propagation. However, above a certain cutoff frequency, transverse electric (TE) and/or transverse magnetic (TM) modes can also propagate, as they do in a waveguide. It is usually undesirable to transmit signals above the cutoff frequency, since it may cause multiple modes with different phase velocities to propagate, interfering with each other. The outer diameter is roughly inversely proportional to the cutoff frequency.

Read more at Wikipedia.org