Modulators & Transmitters

In telecommunications, modulation is the process of varying a periodic waveform, i.e. a tone, in order to use that signal to convey a message, in a similar fashion as a musician may modulate the tone from a musical instrument by varying its volume, timing and pitch. more...

Home
Amplifiers
Audio Accessories & Cables
Cable TV
DVD Players & Recorders
Digital Video Recorders, PVR
Gadgets & Other Electronics
Home Audio
Home Theater Projectors
Home Theater in a Box
Radios: CB, Ham & Shortwave
Satellite Radio
Satellite Radio Accessories
Sirius
Accessory Kits
Antennas
Docking Stands & Mounts
Other
XM Radio
Accessory Kits
Antennas
Docking Stands & Mounts
Modulators & Transmitters
Other
Remotes
Sirius
XM Radio
Satellite TV
Telephones & Pagers
Televisions
VCRs
Vintage Electronics

Normally a high-frequency sinusoid waveform is used as carrier signal. The three key parameters of a sine wave are its amplitude ("volume"), its phase ("timing") and its frequency ("pitch"), all of which can be modified in accordance with a low frequency information signal to obtain the modulated signal.

A device that performs modulation is known as a modulator and a device that performs the inverse operation of demodulation is known as a demodulator (sometimes detector or demod). A device that can do both operations is a modem (a contraction of the two terms).

A simple example: A telephone line is designed for transferring audible sounds, for example tones, and not digital bits (zeros and ones). Computers may however communicate over a telephone line by means of modems, which are representing the digital bits by tones, called symbols. You could say that modems play music for each other. If there are four alternative symbols (corresponding to a musical instrument that can generate four different tones, one at a time), the first symbol may represent the bit sequence 00, the second 01, the third 10 and the fourth 11. If the modem plays a melody consisting of 1000 tones per second, the symbol rate is 1000 symbols/second, or baud. Since each tone represents a message consisting of two digital bits in this example, the bit rate is twice the symbol rate, i.e. 2000 bit per second.

The aim of digital modulation is to transfer a digital bit stream over an analog bandpass channel, for example over the public switched telephone network (where a filter limits the frequency range to between 300 and 3400 Hz) or a limited radio frequency band.

The aim of analog modulation is to transfer an analog lowpass signal, for example an audio signal or TV signal, over an analog bandpass channel, for example a limited radio frequency band or a cable TV network channel.

Analog and digital modulation facilitate frequency division multiplex (FDM), where several low pass information signals are transferred simultaneously over the same shared physical medium, using separate bandpass channels.

The aim of digital baseband modulation methods, also known as line coding, is to transfer a digital bit stream over a lowpass channel, typically a non-filtered copper wire such as a serial bus or a wired local area network.

The aim of pulse modulation methods is to transfer a narrowband analog signal, for example a phone call over a wideband lowpass channel or, in some of the schemes, as a bit stream over another digital transmission system.

Analog modulation methods

In analog modulation, the modulation is applied continuously in response to the analog information signal.

Read more at Wikipedia.org